BSD | Ducati | 1299, 1199R handlebar switch for road or track - 8 functions and Flipper up/down

Left side road or track switch assembly for the following bikes machined from billet aluminium

1199R - 2015 onward
1199 Superleggera
1299
1299 Superleggera

This switch is a direct replacement for the standard left hand switch assembly found on the Ducati bikes listed above, and features all of the standard controls in a billet machined aluminium body.

The kit also includes adaptor wiring enabling the UP and DOWN flipper functions to be controlled using the turn signal switches. This enables the assembly to be used in 2 ways

• Road – Turn signals enabled (UP / DOWN flipper functions not available in this mode)
• Track – UP / DOWN functions enabled (Turn signals disabled in this mode.

Conversion from one mode to another is just a swap of one connector that is accessible without removing any bodywork, so takes seconds.

Each switch is IP67 sealed featuring gold contacts and connects to the bike via a ‘plug n play’ connector through high temperature Raychem race wire. No modification of the bike wiring or steering stops are necessary

Functions:

• Dash mode UP
• Dash Mode DOWN
• Select / Cancel
• Main beam off/on
• Flasher / lap set (finger operated at the rear)
• Left turn
• Right turn
• Horn

Note - Stealth version is available with all black buttons, just request 'stealth' in the notes section of your order.

This assembly is a direct 'plug n play' replacement for the standard left switch cluster but machined into a billet aluminium housing with IP67 sealed switch elements . No re-wiring or programming is required, just plug it in.

Greater crash protection as well as electrical integrity with gold plated contacts

Kit comprises:

• Sealed switch assembly
• Pre-wired connector to suit the standard bike / kit wiring
• retaining screws