Aim LCU ONE CAN Lambda Controller + Analog Interface Kit For Motorcycle

Aim LCU ONE CAN Lambda Controller + Analog interface Kit For Motorcycle is a lambda controller for wide
band BOSCH LSU 4.9 lambda probe. It fits petrol and diesel engines as well as alcohol
based fuel engines. It is intended to check lambda probe is properly working as well as to
transmit Air/Fuel Ratio values or Lambda values both through the CAN bus or through a
serial RS232 bus

All LCU-One lambda controllers use a wide band Bosch LSU 4.9 probe either for its capacity of saving the original calibration for its all life and for its duration: Bosch LSU 4.9 probe, in fact, has been designed to last for more than 100.000 km on a stock car.

Full Control of your engine

The LCU ONE Controller Unit - Analog Interface for Motorcycles can detect punctual Lambda value from 0.65 to 1.6, offering you an extremely precise measurement, very useful for engine tuning.

Through the analysis of the remaining oxygen, LCU-One points out possible oxygen excess/lack in the carburetion, providing an essential information for 4 strokes engines: configurability of Stoichiometric ratio allows LCU-One to be used on petrol powered engines as well as on diesel or on alternative fuel (bio fuel, ethanol) powered ones.

Three variants for all your needs

Aim LCU ONE Controller Unit - Analog Interface for Cars range is available in three different versions:

• LCU-One CAN: uses a CAN bus and is extremely easy to install.
• LCU-One Analog: uses a serial line for programming and an analog output proportional to lambda value. To be even more user-friendly, these two versions of LCU-One switch on/off together with the logger.
• LCU-One CAN + Analog is equipped with both CAN bus and analog output.

All the data you need at your fingertips

LCU-One CAN

• CAN connection

The product configures Stoichiometric point and provides:

• Lambda value and Air/Fuel ratio
• Lambda probe temperature and diagnosis

LCU-One Analog

The product provides Lambda value and Air/Fuel ratio and - thanks to the dedicated Lambda Configurator software, LCU-One Analog allows to configure:

• Stoichiometric point
• Analog output (0-5 Volt)

LCU-One CAN + Analog

The product configures:

• CAN connection+ Analog output
• Stoichiometric point

LCU-One CAN + Analog also provides:

• Lambda value and Air/Fuel ratio
• Lambda probe temperature and diagnosis

Technical Specs

LCU ONE Controller Unit - Analog Interface for Cars technical specs

Dimensions: 80x37x15 mm
Waterproof: IP67

In The Box